Bug 8908
Summary: | 3ware 9650SE -8LPML not recognized by 3w-9xxx driver | ||
---|---|---|---|
Product: | IO/Storage | Reporter: | sven dmitrienko (svedox) |
Component: | SCSI | Assignee: | scsi_drivers-other |
Status: | REJECTED DOCUMENTED | ||
Severity: | high | CC: | protasnb |
Priority: | P1 | ||
Hardware: | All | ||
OS: | Linux | ||
Kernel Version: | 2.6.22.1 | Subsystem: | |
Regression: | --- | Bisected commit-id: |
Description
sven dmitrienko
2007-08-19 11:58:53 UTC
Reply-To: akpm@linux-foundation.org On Sun, 19 Aug 2007 11:51:38 -0700 (PDT) bugme-daemon@bugzilla.kernel.org wrote: > http://bugzilla.kernel.org/show_bug.cgi?id=8908 > > Summary: 3ware 9650SE -8LPML not recognized by 3w-9xxx driver > Product: IO/Storage > Version: 2.5 > KernelVersion: 2.6.20.1 > Platform: All > OS/Version: Linux > Tree: Mainline > Status: NEW > Severity: high > Priority: P1 > Component: Serial ATA > AssignedTo: jgarzik@pobox.com > ReportedBy: svedox@t-online.de > > > Most recent kernel where this bug did not occur: > Distribution: Debian Lenny/Sid > Hardware Environment: Intel Pentium D 820, Intel Mainboard with 955X > Controller > on board > Software Environment: Linux/Debian > Problem Description: The 3w-9xxx kernel driver for 3ware 9xxx SATA RAID > Controller series did not recognize the 3ware 9650SE-8LPML SATA RAID > Controller. I tryed also with original driver from 3ware itself, but this > also > didn't work, because of changes in module interface. If you need tester for > this controller, i can do it for you. > > Steps to reproduce: Get the mentioned card, install it in your compouter, and > attach some sata hd's to it. Compile kernel with 3w-9xxx SATA RAID > driver(SCSI > section) and install it. Include HD's into your fstab.conf. Reboot and watch > boot messages. You will see, that HD's, that are attached to the 3ware > Controller are not found. After boot, put lspci into your linux console. > lspci > shows, here is an unrecognized 3ware Controller card. > It was kernel 2.6.22.1, not 2.6.20.1. have you tried to configure raid disks using the 9650-SE's bios tool, or the 3ware webtool ? Likely the 9650-SE doesn't export unconfigured disks, so they don't show up as SCSI drives to teh kernel. (a 9650SE-8LPML, firmware FE9X 3.06.00.003 driver 2.26.02.008 works on my 2.6.21.5) Sven, can you provide the dmesg and lspci -v please? Basically, we need to know PCI/Vendor ID for your controller. (Reassigning to the scsi_drivers-other@kernel-bugs.osdl.org, instead of CC-ing) The 9650SE (vendor:0x13c1, device id: 0x1004) controller series has been supported by the in-kernel 3w-9xxx driver since 2.6.19 kernel. The user did not properly configure 'single disk' support through the 3ware BIOS, tw_cli or 3dm2 tool. Please close this bug. -Adam Radford Thanks much, closing the bug. |