Steps to reproduce: 1. # Enable fan 2020-04-28 15:28:22 echo -n "Enabling fan at 50/255 ... " hwi=/sys/class/drm/card0/device/hwmon/hwmon1 test -d $hwi && echo 1 > $hwi/fan1_enable && echo 50 > $hwi/pwm1 && echo "Fan OK" 2. Suspend 3. Resume Expected results: fan spinning at 50/255 Actual results: fan doesn't spin Additional information: 09:00.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] Navi 10 [Radeon RX 5600 OEM/5600 XT / 5700/5700 XT] (rev ca) (prog-if 00 [VGA controller]) Subsystem: Sapphire Technology Limited Device e411 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx+ Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 0, Cache Line Size: 64 bytes Interrupt: pin A routed to IRQ 120 Region 0: Memory at e0000000 (64-bit, prefetchable) [size=256M] Region 2: Memory at f0000000 (64-bit, prefetchable) [size=2M] Region 4: I/O ports at e000 [size=256] Region 5: Memory at fcc00000 (32-bit, non-prefetchable) [size=512K] Expansion ROM at 000c0000 [disabled] [size=128K] Capabilities: [48] Vendor Specific Information: Len=08 <?> Capabilities: [50] Power Management version 3 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1+,D2+,D3hot+,D3cold+) Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=0 PME- Capabilities: [64] Express (v2) Legacy Endpoint, MSI 00 DevCap: MaxPayload 256 bytes, PhantFunc 0, Latency L0s <4us, L1 unlimited ExtTag+ AttnBtn- AttnInd- PwrInd- RBE+ FLReset- DevCtl: CorrErr- NonFatalErr- FatalErr- UnsupReq- RlxdOrd+ ExtTag+ PhantFunc- AuxPwr- NoSnoop+ MaxPayload 256 bytes, MaxReadReq 512 bytes DevSta: CorrErr+ NonFatalErr- FatalErr- UnsupReq+ AuxPwr- TransPend- LnkCap: Port #0, Speed 16GT/s, Width x16, ASPM L0s L1, Exit Latency L0s <64ns, L1 <1us ClockPM- Surprise- LLActRep- BwNot- ASPMOptComp+ LnkCtl: ASPM L0s L1 Enabled; RCB 64 bytes Disabled- CommClk+ ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt- LnkSta: Speed 16GT/s (ok), Width x16 (ok) TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt- DevCap2: Completion Timeout: Range ABCD, TimeoutDis+, NROPrPrP-, LTR+ 10BitTagComp+, 10BitTagReq+, OBFF Not Supported, ExtFmt+, EETLPPrefix+, MaxEETLPPrefixes 1 EmergencyPowerReduction Not Supported, EmergencyPowerReductionInit- FRS- AtomicOpsCap: 32bit+ 64bit+ 128bitCAS- DevCtl2: Completion Timeout: 50us to 50ms, TimeoutDis-, LTR+, OBFF Disabled AtomicOpsCtl: ReqEn+ LnkCtl2: Target Link Speed: 16GT/s, EnterCompliance- SpeedDis- Transmit Margin: Normal Operating Range, EnterModifiedCompliance- ComplianceSOS- Compliance De-emphasis: -6dB LnkSta2: Current De-emphasis Level: -3.5dB, EqualizationComplete+, EqualizationPhase1+ EqualizationPhase2+, EqualizationPhase3+, LinkEqualizationRequest- Capabilities: [a0] MSI: Enable+ Count=1/1 Maskable- 64bit+ Address: 00000000fee00000 Data: 0000 Capabilities: [100 v1] Vendor Specific Information: ID=0001 Rev=1 Len=010 <?> Capabilities: [150 v2] Advanced Error Reporting UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol- UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF- MalfTLP- ECRC- UnsupReq- ACSViol- UESvrt: DLP+ SDES+ TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+ MalfTLP+ ECRC- UnsupReq- ACSViol- CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout- AdvNonFatalErr+ CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout- AdvNonFatalErr+ AERCap: First Error Pointer: 00, ECRCGenCap+ ECRCGenEn- ECRCChkCap+ ECRCChkEn- MultHdrRecCap- MultHdrRecEn- TLPPfxPres- HdrLogCap- HeaderLog: 00000000 00000000 00000000 00000000 Capabilities: [200 v1] Resizable BAR <?> Capabilities: [240 v1] Power Budgeting <?> Capabilities: [270 v1] Secondary PCI Express LnkCtl3: LnkEquIntrruptEn-, PerformEqu- LaneErrStat: 0 Capabilities: [2a0 v1] Access Control Services ACSCap: SrcValid- TransBlk- ReqRedir- CmpltRedir- UpstreamFwd- EgressCtrl- DirectTrans- ACSCtl: SrcValid- TransBlk- ReqRedir- CmpltRedir- UpstreamFwd- EgressCtrl- DirectTrans- Capabilities: [2b0 v1] Address Translation Service (ATS) ATSCap: Invalidate Queue Depth: 00 ATSCtl: Enable+, Smallest Translation Unit: 00 Capabilities: [2c0 v1] Page Request Interface (PRI) PRICtl: Enable- Reset- PRISta: RF- UPRGI- Stopped+ Page Request Capacity: 00000100, Page Request Allocation: 00000000 Capabilities: [2d0 v1] Process Address Space ID (PASID) PASIDCap: Exec+ Priv+, Max PASID Width: 10 PASIDCtl: Enable- Exec- Priv- Capabilities: [320 v1] Latency Tolerance Reporting Max snoop latency: 1048576ns Max no snoop latency: 1048576ns Capabilities: [400 v1] Data Link Feature <?> Capabilities: [410 v1] Physical Layer 16.0 GT/s <?> Capabilities: [440 v1] Lane Margining at the Receiver <?> Kernel driver in use: amdgpu Kernel modules: amdgpu My GPU VBIOS can be found here: https://www.techpowerup.com/vgabios/219169/sapphire-rx5600xt-6144-200225
Ping
I have the same problem on a Powercolor RX 5700 XT. fan1_enable is set to 1 and when I enter echo 50 > /sys/class/drm/card0/device/hwmon/hwmon0/pwm1 pwm1 is still "0" even though the fan is running. lspci output: 09:00.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] Navi 10 [Radeon RX 5600 OEM/5600 XT / 5700/5700 XT] (rev c1) (prog-if 00 [VGA controller]) Subsystem: Tul Corporation / PowerColor Device 2398 Flags: bus master, fast devsel, latency 0, IRQ 97, IOMMU group 2 Memory at e0000000 (64-bit, prefetchable) [size=256M] Memory at f0000000 (64-bit, prefetchable) [size=2M] I/O ports at e000 [size=256] Memory at fcc00000 (32-bit, non-prefetchable) [size=512K] Expansion ROM at 000c0000 [disabled] [size=128K] Capabilities: [48] Vendor Specific Information: Len=08 <?> Capabilities: [50] Power Management version 3 Capabilities: [64] Express Legacy Endpoint, MSI 00 Capabilities: [a0] MSI: Enable+ Count=1/1 Maskable- 64bit+ Capabilities: [100] Vendor Specific Information: ID=0001 Rev=1 Len=010 <?> Capabilities: [150] Advanced Error Reporting Capabilities: [200] Physical Resizable BAR Capabilities: [240] Power Budgeting <?> Capabilities: [270] Secondary PCI Express Capabilities: [2a0] Access Control Services Capabilities: [2b0] Address Translation Service (ATS) Capabilities: [2c0] Page Request Interface (PRI) Capabilities: [2d0] Process Address Space ID (PASID) Capabilities: [320] Latency Tolerance Reporting Capabilities: [400] Data Link Feature <?> Capabilities: [410] Physical Layer 16.0 GT/s <?> Capabilities: [440] Lane Margining at the Receiver <?> Kernel driver in use: amdgpu Kernel modules: amdgpu
(In reply to Andreas Prittwitz from comment #2) > I have the same problem on a Powercolor RX 5700 XT. Is this still an issue with 5.15.12?
(In reply to Artem S. Tashkinov from comment #3) > (In reply to Andreas Prittwitz from comment #2) > > I have the same problem on a Powercolor RX 5700 XT. > > Is this still an issue with 5.15.12? No, it is not for me. I simply forgot about this bug, sorry.