Linux version 2.6.15 (tesarik@golias) (gcc version 3.3.5 (Debian 1:3.3.5-13)) #5 Fri Apr 28 12:28:33 CEST 2006
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
 BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e9c00 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 00000000077f0000 (usable)
 BIOS-e820: 00000000077f0000 - 00000000077ffc00 (ACPI data)
 BIOS-e820: 00000000077ffc00 - 0000000007800000 (ACPI NVS)
 BIOS-e820: 00000000fffe0000 - 0000000100000000 (reserved)
119MB LOWMEM available.
On node 0 totalpages: 30704
  DMA zone: 4096 pages, LIFO batch:0
  DMA32 zone: 0 pages, LIFO batch:0
  Normal zone: 26608 pages, LIFO batch:7
  HighMem zone: 0 pages, LIFO batch:0
DMI 2.3 present.
ACPI: RSDP (v000 PTLTD                                 ) @ 0x000f6e90
ACPI: RSDT (v001 PTLTD    RSDT   0x06040000  LTP 0x00000000) @ 0x077fbdc2
ACPI: FADT (v001 COMPAQ Borg     0x06040000 PTL_ 0x000f4240) @ 0x077ffb64
ACPI: BOOT (v001 PTLTD  $SBFTBL$ 0x06040000  LTP 0x00000001) @ 0x077ffbd8
ACPI: DSDT (v001 Compaq Wrangler 0x06040000 MSFT 0x0100000d) @ 0x00000000
ACPI: PM-Timer IO Port: 0x8008
Allocating PCI resources starting at 10000000 (gap: 07800000:f87e0000)
Built 1 zonelists
Kernel command line: root=/dev/hda3 ro resume=/dev/hda8
Initializing CPU#0
PID hash table entries: 512 (order: 9, 8192 bytes)
Detected 697.449 MHz processor.
Using pmtmr for high-res timesource
Console: colour VGA+ 80x25
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 118944k/122816k available (1498k kernel code, 3344k reserved, 473k data, 124k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 1396.07 BogoMIPS (lpj=698038)
Mount-cache hash table entries: 512
CPU: After generic identify, caps: 0383f9ff 00000000 00000000 00000000 00000000 00000000 00000000
CPU: After vendor identify, caps: 0383f9ff 00000000 00000000 00000000 00000000 00000000 00000000
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 128K
CPU: After all inits, caps: 0383f9ff 00000000 00000000 00000040 00000000 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
mtrr: v2.0 (20020519)
CPU: Intel Celeron (Coppermine) stepping 06
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
ACPI: setting ELCR to 0400 (from 0a00)
NET: Registered protocol family 16
ACPI: bus type pci registered
PCI: PCI BIOS revision 2.10 entry at 0xfd83e, last bus=1
PCI: Using configuration type 1
ACPI: Subsystem revision 20050902
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (0000:00)
PCI: Probing PCI hardware (bus 00)
PCI quirk: region 8000-80ff claimed by vt82c586 ACPI
PCI quirk: region 8080-808f claimed by vt82c686 SMB
PCI: Firmware left 0000:00:09.0 e100 interrupts enabled, disabling
PCI: Lucent WinModem at 0000:00:09.1 claims 8250-compatibility;changing to OTHER
Boot video device is 0000:01:00.0
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs *9 11 12)
ACPI: PCI Interrupt Link [LNKB] (IRQs 9 *11 12)
ACPI: PCI Interrupt Link [LNKC] (IRQs *9 11 12)
ACPI: PCI Interrupt Link [LNKD] (IRQs 9 *11 12)
ACPI: Embedded Controller [EC0] (gpe 1)
ACPI: Power Resource [PLPC] (on)
PCI: Using ACPI for IRQ routing
PCI: If a device doesn't work, try "pci=routeirq".  If it helps, post a report
PCI: Bridge: 0000:00:01.0
  IO window: disabled.
  MEM window: f4100000-f57fffff
  PREFETCH window: 14000000-140fffff
PCI: Bus 2, cardbus bridge: 0000:00:0a.0
  IO window: 00001800-000018ff
  IO window: 00001c00-00001cff
  PREFETCH window: 10000000-11ffffff
  MEM window: 12000000-13ffffff
PCI: Setting latency timer of device 0000:00:01.0 to 64
PCI: Enabling device 0000:00:0a.0 (0000 -> 0003)
ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 11
PCI: setting IRQ 11 as level-triggered
ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
Simple Boot Flag at 0x37 set to 0x1
Initializing Cryptographic API
io scheduler noop registered
io scheduler cfq registered
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller at PCI slot 0000:00:07.1
VP_IDE: chipset revision 16
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt82c686a (rev 22) IDE UDMA66 controller on pci0000:00:07.1
    ide0: BM-DMA at 0x1460-0x1467, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x1468-0x146f, BIOS settings: hdc:DMA, hdd:pio
Probing IDE interface ide0...
hda: TOSHIBA MK1016GAP, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
hdc: QSI CD-ROM SCR-242, ATAPI CD/DVD-ROM drive
ide1 at 0x170-0x177,0x376 on irq 15
hda: max request size: 128KiB
hda: 19640880 sectors (10056 MB), CHS=19485/16/63, UDMA(33)
hda: cache flushes not supported
 hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 > hda3
mice: PS/2 mouse device common for all mice
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
TCP bic registered
Using IPI Shortcut mode
ACPI wakeup devices: 
PWRB  LID PCI0 USB0 MODM PMOD CRD0 
ACPI: (supports S0 S1 S4 S5)
input: AT Translated Set 2 keyboard as /class/input/input0
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 124k freed
NET: Registered protocol family 1
Adding 497972k swap on /dev/hda8.  Priority:-1 extents:1 across:497972k
EXT3 FS on hda3, internal journal
hdc: ATAPI 24X CD-ROM drive, 128kB Cache, DMA
Uniform CD-ROM driver Revision: 3.20
input: PS/2 Generic Mouse as /class/input/input1
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS on hda7, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS on hda6, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
Linux agpgart interface v0.101 (c) Dave Jones
agpgart: Detected VIA Apollo ProMedia/PLE133Ta chipset
agpgart: AGP aperture is 64M @ 0xf8000000
parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,ECP,DMA]
usbcore: registered new driver usbfs
usbcore: registered new driver hub
USB Universal Host Controller Interface driver v2.3
ACPI: PCI Interrupt 0000:00:07.2[D] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
uhci_hcd 0000:00:07.2: UHCI Host Controller
uhci_hcd 0000:00:07.2: new USB bus registered, assigned bus number 1
uhci_hcd 0000:00:07.2: irq 11, io base 0x00001440
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 9
PCI: setting IRQ 9 as level-triggered
ACPI: PCI Interrupt 0000:00:07.5[C] -> Link [LNKC] -> GSI 9 (level, low) -> IRQ 9
PCI: Setting latency timer of device 0000:00:07.5 to 64
e100: Intel(R) PRO/100 Network Driver, 3.4.14-k4-NAPI
e100: Copyright(c) 1999-2005 Intel Corporation
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11
e100: eth0: e100_probe: addr 0xf4020000, irq 11, MAC addr 00:D0:59:2A:3F:06
ACPI: PCI Interrupt 0000:00:0a.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
Yenta: CardBus bridge found at 0000:00:0a.0 [0e11:b103]
Yenta: Enabling burst memory read transactions
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:00:0a.0, mfunc 0x00001012, devctl 0x64
Yenta: ISA IRQ mask 0x0038, PCI irq 11
Socket status: 30000006
ACPI: Battery Slot [BAT1] (battery present)
ACPI: AC Adapter [ACAD] (on-line)
ACPI: CPU0 (power states: C1[C1] C2[C2])
ACPI: Power Button (FF) [PWRF]
ACPI: Power Button (CM) [PWRB]
ACPI: Sleep Button (CM) [SLPB]
ACPI: Lid Switch [LID]
ACPI: Thermal Zone [THRM] (50 C)
lp0: using parport0 (interrupt-driven).
e100: eth1: e100_watchdog: link up, 100Mbps, full-duplex
NET: Registered protocol family 17